HEGEL pre amplifiers are different than
other pre amplifiers.
The basic technology used in almost
all pre amplifiers on the market
are more or less the same.
Standard circuit configurations such
as global feedback technology or
local feedback technology are used.
These standard technologies has been
available for more than 30 years,
and is a mature technology. This
means most amplifier technologies
are more or less the same.
HEGEL decided there was no point in
making just another pre amplifier using
the standard audio amplifier technology used
by a lot of other audio amplifier manufacturers.
HEGEL wanted to do something
different.
All HEGEL
pre amplifiers are divided into 2
completely separate circuit blocks:
the first amplifier block is using a
digitally controlled volume control
gain stage that will set the needed
voltage gain and the second
amplifier block will amplify the
current needed to drive the
connected signal cables.
All Hegel pre amplifiers use completely
separate power supplies for the
left and the right channel. This makes
sure the crosstalk between the Left
and right channel is lowest possible
All HEGEL pre amplifiers are fully
balanced from input to output,
including the crucial volume control
stage. This makes sure the
distortion is the lowest possible
and keeps the dynamic range as high
as possible.
These new and innovative
technologies are designed to give
each separate amplifier block the
best possible work conditions, and
to prevent the different amplifier
blocks from having any influence on
each other. This gives the best
possible overall sound quality.
For more information about
why
the sum of these new and innovative technological
solutions will give better sound
quality,
please read about the
HEGEL
Audio Amplifier Technology |
HEGEL Amplifier Technology